LAND4 for ARCHICAD

Print

Create Volumetrics Surface

Volumetrics Surface

The Create Volumetrics Surface tool enables you to compare two LANDSurfaces.

The outcome of this comparison will be a Volumetrics Surface, a resulting surface showing the height or level difference between the two selected LANDSurfaces.

Create Volumetrics Surface

To use the Create Volumetrics Surface tool:

  1. Go to:
    • LAND4/Group Palettes/Show LANDSurface Palette, or
    • LAND4 Palette/Surfaces.
  2. Press Create Volumetrics Surface.
LANDSurface Palette/Create Volumetrics Surface
  1. The Volumetrics Palette will open.
  2. Use pen tool to select the LANDSurfaces to be compared (In the example below: New Terrain and Existing Terrain ).
  3. Define the area for the resulting surface:
    • use Magic Wand, or
    • draw closed polygon (LAND4 uses ARCHICAD polyline tool for this).
  4. Once this process is done, the Resulting Surface will be generated as a LANDSurface.
  5. Place the Volumetrics Stamp anywhere on the canvas.

Automatically updated

If one of the selected parent LANDSurfaces is edited, the Resulting Surface will automatically be updated accordingly.

Note! To update Volumetrics Stamp, press Recalculate Volumetrics.


Selected LANDSurfaces

LANDSurfaces, 2D

The two selected overlapping LANDSurfaces, 2D

LANDSurfaces, 3D

The two selected overlapping LANDSurfaces, 3D

Volumetrics Surface, 3D

Once this process is done, the Resulting Surface will be generated in 3D:

The Resulting Surface showing level lines, 3D

Resulting Surface, CUT and FILL

Resulting Surface. CUT and FILL in section view.

The Volumetrics Stamp

The Volumetrics Stamp offers information on e.g. Area ID, Gross Volume, FILL or CUT Volume and volume to be added or removed from the site.

Placement of stamp

The Volumetrics Stamp can be placed anywhere on the screen.

LAND4 Volumetrics Stamp

Recalculate Volumetrics

ReCalculate Volumetrics can be used to update the Volumetrics Stamp, when one or both parent LANDSurfaces have been edited.

To update stamp

  1. Select stamp to be updated.
  2. Go to:
    • LAND4/Group Palettes/Show LANDSurface Palette, or
    • LAND4 Palette/Surfaces.
  3. Press ReCalculate Volumetrics.
Recalculate Volumetrics. Button is marked on the LAND4 Palette.

Table of Contents